Recent questions tagged 1983

0 votes

0 answers

What is the maximum power transmitted without belt slipping in any one of the pulleys?

asked Nov 14, 2017 in MD by chandu (215k points)

0 votes

0 answers

Find the tooth loads and bearing reactions for the shaft shown in figure used to transmit power

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

The welds are produced by shielded arc welding process with a permissible strength of 15 kgf / mm2.

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

The proportions of a common rivet and the guide lines for designing a single riveted lap joint are given:

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Find the ratio of these limiting loads

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Which one member of the coupling will you design as a slightly weaker element and why?

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

What are the similarities and differences between PERT and CPM?

asked Nov 9, 2017 in im&or by chandu (215k points)

0 votes

0 answers

What is LINEAR PROGRAMMING?

asked Nov 8, 2017 in im&or by chandu (215k points)

0 votes

0 answers

What is understood by Fibre-reinforces Plastics (FRP)?

asked Nov 8, 2017 in engg-materials by chandu (215k points)

0 votes

0 answers

What are the various characteristics of plastics? Distinguish between thermo sets and thermoplastics.

asked Nov 8, 2017 in engg-materials by chandu (215k points)

0 votes

0 answers

What are the differences in principles and practices between case hardening and full hardening heat treatments?

asked Nov 8, 2017 in engg-materials by chandu (215k points)

0 votes

0 answers

What is its significance to a Mechanical / Metallurgical engineer?

asked Nov 8, 2017 in engg-materials by chandu (215k points)

0 votes

0 answers

Bring out the differences and similarities between alloys and compounds.

asked Nov 8, 2017 in engg-materials by chandu (215k points)

0 votes

0 answers

Represent schematically the three types of unit cells observed in metal structures

asked Nov 8, 2017 in engg-materials by chandu (215k points)

0 votes

0 answers

Derive an expression for the mean temperature difference in a parallel flow heat exchanger

asked Nov 7, 2017 in HT by chandu (215k points)

0 votes

0 answers

Calculated on the basis of an average thermal conductivity?

asked Nov 5, 2017 in HT by chandu (215k points)

0 votes

0 answers

The high temperature surface in the direction of decreasing temperature.

asked Nov 5, 2017 in HT by chandu (215k points)

0 votes

0 answers

Determine the quantity of carbon remaining un burnt in each kg. of the fuel fired in the furnace.

asked Nov 2, 2017 in Thermal by chandu (215k points)

0 votes

0 answers

Determine (i) the isentropic heat drop in the stage (ii) the energy lost in the nozzles

asked Nov 1, 2017 in Thermal by chandu (215k points)

0 votes

0 answers

Determine the whether a convergent or a convergent-divergent nozzle is to be used

asked Nov 1, 2017 in Thermal by chandu (215k points)

Page:

...