Recent questions in md

0 votes

0 answers

Which of the following stresses are associated with the tightening of a nut on a stud?

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following is true about following specifications Hex Bolt M 16NL-IS:1363

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The ideal material for shafts transmitting power is

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The value of the minimum ultimate strength according to modified Goodman relation will be

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

For a component made of ductile material, the failure criterion will be

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Endurance limit is of primary concern in the design of a/an

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

What is the factor of safety using maximum shear stress theory?

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The life of the bearing increases to

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

In the design of connecting rod small end bearing, the value of permissible bearing pressure to be used is:

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

A rotating shaft carrying a unidirectional transverse load is subjected to:

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Fatigue strength of a rod subjected to cyclic axial force is less than that of a rotating beam of

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

What is the maximum shear stress developed corresponding to the same torque?

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following joins:

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Who postulated the maximum distortion energy theory?

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

In designing a shaft for variable loads, the S.N. diagram can be drawn by:

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Disruptive strength is the maximum strength of a metal, when

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List-I (Theory of Failure) with List- Il (Predicted Ratio of Shear Stress to Direct Stress )

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The maximum distortion energy theory of failure is suitable to predict the failure of which one of the following

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The factor of safety of the design is

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The failure load is

asked Dec 18, 2017 in md by chandu (215k points)

Page:

« prev
1
...
16
17
18
19
20
21
next »

Recent questions in md

...