Recent questions in md

0 votes

0 answers

When a nut is tightened by placing a washer below it the bolt will be subjected to

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

In the welded joint shown in the given figure if the weld at B has thicker fillets than at

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The average tensile stress in the weld is given by

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The shear stress in the weld is given by

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The tension in the bolt after this is

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

When the coupler of a turn buckle is turned in one direction both the connecting rods m

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

For bolts of uniform strength, the shank diameter is made equal to

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The allowable shearing load on per cm length of the weld is

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding power screws:

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Uniform strength bolts are used for resisting impact loads

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The following two figure show welded joints (XXX indicated welds)

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List-I (Types of joints) and List – II (An element of the joint)

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Which one of the following structural joints with 10 rivets and same size of plate and material will be most efficient?

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The most efficient riveted joint possible is one which would be as strong in tension, shear an bearing as

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Type of Joints) and List –II (Made of Joining members)

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The frictional torque for square thread at mean radius while raising load is given be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The frictional torque for square thread at mean radius while raising load is given be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The frictional torque for square thread at mean radius while raising load is given be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The frictional torque for square thread at mean radius while raising load is given be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

In a flat collar pivot bearing, the moment due to friction is proportional to

asked Dec 19, 2017 in md by chandu (215k points)

Page:

« prev
1
...
15
16
17
18
19
20
21
next »

Recent questions in md

...