Recent questions in md

0 votes

0 answers

A. Crank shaft B. Wire shaft C. Axle D. Plain shaft

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In equilibrium position, the journal inside a journal bearing remains

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In an oil – lubricated journal bearing, coefficient of friction between the journal and the bearing

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The design of the pin of a rocker arm of an I.C. engine is based on

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which one of the following loadings is considered for design of axles?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following statements about antifriction bearings

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

If the combined shock and fatigue factor for bending is 1.5 and combined shock and fatigue factor for torsion is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The effect of keyways on a shaft is to reduce its load carrying capacity and to increase its

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In hydrodynamic journal bearings, the rotating journal is held in

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

A friction circle is drawn when a journal rotates in bearing. Its radius depends on the coefficient of friction and the

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In the assembly of pulley, key and shaft

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which key is preferred for the condition where a large amount of impact torque is to be transmitted

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Ball bearings are provided with a cage

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which bearing is preferred for oscillating conditions?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding the ends of the pressure vessels flanged by pre-tensioned bolts:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The required length of the key would be

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The permissible direct shear stress of the weld is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The parallel fillet welded joint is designed for

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Rivets undergo single shear in

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

What will be value of if the total load carried by the joint is 85 kN

asked Dec 20, 2017 in md by chandu (215k points)

Page:

« prev
1
...
12
13
14
15
16
17
18
19
20
21
next »

Recent questions in md

...