Recent questions in md

0 votes

0 answers

The necessary length of the key for equal shear strength of shaft and key will be

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The journal while rotating inside a bearing automatically shifts its center to one side and thus the journal is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Removal of metal particles from the race-way of bearing, known is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

If the load on a ball bearing is reduced to one third, then its life would increase by:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The bearing characteristic number depends on :

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In case of hydrodynamic lubrication in a journey bearing the attitude is the ratio of:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The basic reason why shafts are made of steel and its alloys is:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following is a joint formed by interference fits?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In the assembly of pulley, key and shaft:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The shoulder provided on the shaft using antifriction bearings is to prevent:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The power lost in friction is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The hardness value of the material being tested?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The piston pin bearing in heavy duty diesel engines are

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In hydrodynamic bearings

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The coefficient of friction µ will change as

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

An axle is a machine part that is subjected to

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

When a journal rotates in anticlockwise direction at high speed in a bearing having adequate

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Antifriction bearings are normally used in shafts

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Splines are useful in situations where the connected component is required to

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

A shaft transmits 1000kW of power at 1000rad/s

asked Dec 20, 2017 in md by chandu (215k points)

Page:

« prev
1
...
8
9
10
11
12
13
14
15
16
...
21
next »

Recent questions in md

...