Recent questions tagged power-plant

0 votes

0 answers

Sketch five cycles (all versions of Rankine cycle)

asked Oct 27, 2017 in TD by chandu (215k points)

0 votes

0 answers

Find Required mass of ocean flow water.

asked Oct 27, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Determine the thermal efficiency of the cycle.

asked Oct 26, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Give a practical feed heating arrangement of a 660 MW steam power plant by showing steam and feed flow paths.

asked Oct 25, 2017 in IC engines by chandu (215k points)

0 votes

0 answers

Draw the draught distribution considering balanced draught system in a generator

asked Oct 25, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Show the effect of variation of back pressure on distribution of pressure and velocity

asked Oct 25, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Give a cylinder layout of a 500 MW steam turbine and explain the reasons of double flow cylinders used.

asked Oct 25, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Discuss the purpose of drum used in boiler and show internal details for mechanism of separation of moisture in drum.

asked Oct 25, 2017 in power plant by chandu (215k points)

0 votes

0 answers

What is the reason that thermal efficiency of gas turbine plant increases with decrease in compressor inlet temperature?

asked Oct 25, 2017 in power plant by chandu (215k points)

0 votes

0 answers

The table at a travel rate of 100 mm/min?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Why is feedback not possible in open-loop control system?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

How are metal tooth-paste tubes made commercially?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

What percentage of oxygen is supplied by the torch in any one of the fuel gases?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

What are the differences between interchangeability and selective assembly?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

In a metal cutting operating, the following equation for tool-life was obtained for H.S.S. tool:

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Compression for both cylinders. Which one of the following is the correct expression for Minimum work done?

asked Oct 16, 2017 in RAC by chandu (215k points)

0 votes

0 answers

In a nuclear reactor what is the purpose of control rod?

asked Oct 16, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

Which one of the following equations is correct for the heterogeneous thermal reactor?

asked Oct 16, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

Which of the following components improves the plant efficiency?

asked Oct 16, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

Which one of the following defines the degree of reaction for steam turbines?

asked Oct 16, 2017 in power-plant by chandu (215k points)

Page:

1
2
3
4
5
...
11
next »

...