Recent questions tagged 2010

0 votes

0 answers

What is the reason that thermal efficiency of gas turbine plant increases with decrease in compressor inlet temperature?

asked Oct 25, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Assume heater and hemispherical surface are opaque, diffuse and gray.

asked Oct 25, 2017 in HT by chandu (215k points)

0 votes

0 answers

Sketch the variation in local heat transfer coefficient along the length of conduit.

asked Oct 25, 2017 in HT by chandu (215k points)

0 votes

0 answers

Calculate the following.

asked Oct 25, 2017 in TD by chandu (215k points)

0 votes

0 answers

The pressure and velocity of fluid just before the shock and pressure and temperature after the shock.

asked Oct 25, 2017 in FM&Compressible by chandu (215k points)

0 votes

0 answers

Show that the kinetic energy correction factor, a and momentum correction factor

asked Oct 25, 2017 in TD by chandu (215k points)

0 votes

0 answers

Carnot engine

asked Oct 25, 2017 in TD by chandu (215k points)

0 votes

0 answers

Average flow angle and total pressure loss coefficient.

asked Oct 25, 2017 in FM&Compressible by chandu (215k points)

0 votes

0 answers

How long it will take for the sphere to cool down ?

asked Oct 25, 2017 in HT by chandu (215k points)

0 votes

0 answers

Show Fanno line in adiabtatic flow with friction on h-s diagram & explain the physical significance.

asked Oct 25, 2017 in FM&Compressible by chandu (215k points)

0 votes

0 answers

For compression work to be minimum, what should be process of compression? Is it used din practice?

asked Oct 25, 2017 in TD by chandu (215k points)

0 votes

0 answers

What is total transportation cost? How can this be checked for optimality?

asked Oct 24, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Identify three core components of TPS

asked Oct 24, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Determine the trial limits and revised control limits for a u-chart using the data in the table

asked Oct 24, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

Determine the trial central line and control limits for a p-chart using the following data

asked Oct 24, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The table at a travel rate of 100 mm/min?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

Why is feedback not possible in open-loop control system?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

How are metal tooth-paste tubes made commercially?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

What percentage of oxygen is supplied by the torch in any one of the fuel gases?

asked Oct 24, 2017 in power plant by chandu (215k points)

0 votes

0 answers

What are the principles of TQM in such applications?

asked Oct 24, 2017 in IM&OR by chandu (215k points)

Recent questions tagged 2010

Categories

Most popular tags