Recent questions tagged 2008

0 votes

0 answers

Consider the following statements about radial cams:

asked Oct 11, 2017 in TOM by chandu (215k points)

0 votes

0 answers

An isochronous governor

asked Oct 11, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Simple-mechanisms

asked Oct 11, 2017 in TOM by chandu (215k points)

0 votes

0 answers

In a four – bar linkage if coupler is the shortest link a double- rocker mechanism will result

asked Oct 11, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The ratio of pipe frictional losses in the new arrangement to that in the original configuration would be

asked Sep 24, 2017 in fm&turbo by chandu (215k points)

0 votes

0 answers

The Reynolds number, based on the pipe diameter

asked Sep 23, 2017 in fm&turbo by chandu (215k points)

0 votes

0 answers

The radial component of the fluid acceleration at r = R is

asked Sep 17, 2017 in fm&turbo by chandu (215k points)

0 votes

0 answers

which one of the following is a necessary condition?

asked Sep 16, 2017 in fm&turbo by chandu (215k points)

0 votes

0 answers

Radius of the Mohr’s circle, charactering the state of stress at the point, is

asked Sep 14, 2017 in fm&turbo by chandu (215k points)

0 votes

0 answers

The loss of torque due to the viscosity of the lubricant is

asked Sep 13, 2017 in fm&turbo by chandu (215k points)

0 votes

0 answers

The exit temperature of the cold fluid is

asked Sep 12, 2017 in HT by chandu (215k points)

0 votes

0 answers

The fraction of the thermal radiation leaving the larger surface and striking itself is

asked Sep 12, 2017 in HT by chandu (215k points)

0 votes

0 answers

Thermal boundary layer thickness at the same location is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

The value of $\partial T/\partial X$ and $\partial T/\partial y$ P at surface are

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

Assuming the face PQRS to be at uniform temperature, its steady state temp is

asked Sep 11, 2017 in HT by chandu (215k points)

0 votes

0 answers

Estimated demand for end product P is as follows

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The processing time (in days) is given in the table below. The holding cost for each job is Rs. K per day.

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The actual demand shows a step increase from d1 to d2 at a certain time. Subsequently,

asked Sep 9, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The best upper bound for this number is

asked Sep 8, 2017 in IM&OR by chandu (215k points)

0 votes

0 answers

The probability density function f(t) of the inter-arrival time is given by

asked Sep 7, 2017 in IM&OR by chandu (215k points)

Recent questions tagged 2008

Categories

Most popular tags