Recent questions tagged 2001

0 votes

0 answers

Calculate the principal stresses and orientations of the principal planes on the outer surface of the tube.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Find the thickness of the tube limiting the outside diameter to 50 mm so as to ensure a factor of safety of 4.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Determine the diameter of the shaft.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Draw the variations of ‘SF’ and ‘BM’ in both the cases.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Draw the variations of ‘SF’ and ‘BM’ in both the cases.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

What is meant by point of contra flexure or point of inflection in a beam? Show the same for the beam given below:

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the normal and shear stresses on the plane of maximum shear stress.

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

Discuss the technical and economic reasons leading to the development of Non Traditional Machining (NTM) processes.

asked Nov 21, 2017 in production by chandu (215k points)

0 votes

0 answers

What are the feature of an intelligent robot ?

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

Explain the difference between hard and soft automation. Why are they so called?

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

Comment on the machined surface characteristics obtained after the EDM process.

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

Differentiate between cold, warm and hot working of metals.

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

What is diffusion welding?

asked Nov 19, 2017 in production by chandu (215k points)

0 votes

0 answers

Describe any four common types of discontinuities that may develop in a welded joint

asked Nov 19, 2017 in production by chandu (215k points)

0 votes

0 answers

Why a large sphere solidifies and cools to ambient temperature at a much slower rate than does a smaller sphere?

asked Nov 17, 2017 in production by chandu (215k points)

0 votes

0 answers

Discuss in brief the flank and crater tool wear mechanisms.

asked Nov 16, 2017 in production by chandu (215k points)

0 votes

0 answers

Find the length of the belt required for both cases.

asked Nov 14, 2017 in MD by chandu (215k points)

0 votes

0 answers

What is concurrent engineering?

asked Nov 12, 2017 in im&or by chandu (215k points)

0 votes

0 answers

Compute the standard time for the operation.

asked Nov 12, 2017 in im&or by chandu (215k points)

0 votes

0 answers

What is JIT ? What is the primary benefit derived from its adoption?

asked Nov 12, 2017 in im&or by chandu (215k points)

Recent questions tagged 2001

Categories

Most popular tags