0 votes
74 views
asked in production by (215k points)
Discuss in brief the flank and crater tool wear mechanisms.

      In a certain machining operation with a culling speed of 50 m/min, tool life of 45 minutes was observed. When the cutting speed was increased to 100 m/min, the tool life decreased to 10 minutes. Estimate the cutting speed for maximum productivity, if tool change time is 2 minutes.

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...