0 votes
46 views
asked in MD by (215k points)
Design a set of stepped pulleys to drive a machine from a counter-shaft that runs at 220 rpm. The centre distance between the two sets of pulleys is 2 m. The diameter of the smallest step on the countershaft is 160 mm. The machine is to run at 80, 100 and 130 rpm and should be able to rotate in either directions. Find the length of the belt required for both cases.

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...