Recent questions

0 votes

0 answers

Write down the expressions for the friction torque in case of flat pivots based

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Explain carefully the advantages obtained by increasing the addendum height for the smaller wheel

asked Aug 30, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The behaviour of a bimetallic strip when heated

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

By conjugate beam method, the slope at any section of a beam is?

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Sectional modulus of a pipe

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

The equivalent bending moment of a shaft

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Percentage change in volume of a thin cylinder under internal pressure

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Stiffness, if the number of turns in a spring are halved

asked Aug 30, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Cast iron specimen in a torsion test gives

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

Alloying elements for tool steel and its improved mechanical property

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

Causes of tool wear

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

time taken for reducing the diameter by turning on a lathe

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

The amount of offset of tail stock for turning taper

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

Unconventional machining method and its application

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

Processes and their tolerances obtained

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

Operation and its explanation

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

This air is then churned for a while, by a paddle wheel connected to an external motor

asked Aug 30, 2017 in TD by chandu (215k points)

0 votes

0 answers

Casting Process and its applications

asked Aug 30, 2017 in production by chandu (215k points)

0 votes

0 answers

The irreversibility (in W) due to heat transfer through the wall is ______

asked Aug 30, 2017 in TD by chandu (215k points)

0 votes

0 answers

Plain carbon steel specimens structures observed at different zones

asked Aug 30, 2017 in production by chandu (215k points)

Categories

Most popular tags