Recent questions in SOM&MD

0 votes

0 answers

Find the deflection at the free end.

asked Oct 27, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Compare the flexural strengths of the following three beams of equal weight.

asked Oct 27, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Calculate the percentage saving in material if the material to be used is also the same.

asked Oct 27, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Determine the force P required to develop the braking torque of magnitude 400 Nm.

asked Oct 27, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Determine the external diameter of the column.

asked Oct 27, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Determine the change in angle (in degrees) between OC and OD after application of stresses

asked Oct 26, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Determine the maximum bending stress at section B of the beam.

asked Oct 26, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Take flexural rigidity of the beam as EI.

asked Oct 26, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

, what is the maximum permissible value of T to avoid failure according to Tresca’s failure theory?

asked Oct 26, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Classify stainless steels based on the metallurgical considerations.

asked Oct 26, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Explain the reason for such failure and mention about the dominating stress causing failure.

asked Oct 26, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Calculate the diameters of the shaft using ASME Code for transmission shafting on the basis of maximum shearing stress

asked Oct 24, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Why is the former preferred to the latter?

asked Oct 24, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

What is the maximum value of torque T

asked Oct 24, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Calculate the diameters of the shaft using ASME Code

asked Oct 1, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

what should be the minimum safe diameters of the shaft.

asked Oct 1, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Sketch the Mohr's stress circle for pure shear stress state

asked Oct 1, 2017 in SOM&MD by chandu (215k points)

+1 vote

1 answer

shear stress in punching

asked Oct 1, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

What is the flexural rigidity (EI) of the beam

asked Aug 31, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

What are the directions of principal planes with respect to plane BC?

asked Aug 31, 2017 in SOM&MD by chandu (215k points)

Page:

1
2
3
4
next »

Recent questions in SOM&MD

...