0 votes
52 views
asked in som by (215k points)

         A Thin cylinder with closed ends has an internal diameter of 50mm and a wall thickness of 2.5mm. It is subjected to an axial pull of 10kN and a torque of 500 Nm while under an internal pressure of 6 MN/m2.

(i)   Determine the principal stresses in the tube and the maximum shear stress.

(ii)  Represents the stress configuration on a square element taken in the load direction with direction and magnitude indicated (schematic).

(iii) Sketch the Mohr’s stress circle .

                                        

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...