0 votes
124 views
asked in production by (215k points)

Calculate the fundamental deviation and tolerance and hence the limits of size for the shaft and hole for the following fit 64H8 –f7 mm.  The diameter steps are 50 mm and 80 mm. For shaft designation f, upper deviation is assumed as –5.5 D0.41.

         Data:      For       tolerance

                        H 8      25 i

                        f 7        16i     

                                            

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...