0 votes
70 views
asked in production by (215k points)
A mass produced shaft has dimension 20 0.01mm as its diameter. The ring gauge for checking the shaft has (a) gauge tolerance equal to 10% of work-piece tolerance, (b) wear allowance equal to gauge tolerance and (c) gauge tolerance is spread equally above and below the nominal gauge size. Calculate the diameters of GO and No GO ends of workshop ring gauge. Also sketch the tolerance diagram.

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...