Recent questions tagged tom

0 votes

0 answers

The working surface above the pitch surface of the gear tooth is termed as

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The torque which must be applied to A will be

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

If the arm C makes three revolutions the number of revolutions made by B will be

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

In the case of an involute toothed gear involute starts from

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

A reverted gear train is one in which the output shaft and input shaft

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List – I (Positioning of two shafts) with List – II (Possible connection)

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Epicyclic gear trains

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Overall speed ratio of the train is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

If both have the same size of addendum, then there will be an interference between the

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The number of turns made by the smaller gear for one revolution of arm about the centre of the bigger gear is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List – I with List – II and select the correct answer using the codes given below the lists:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List – I with List – II and select the correct answer using the codes given below the lists:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The gear train usually employed in clocks is a

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which one of the following is true for in volute gears?

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which one of the following pairs is not correctly matched?

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The equivalent inertia of disc of B at the speed of shaft A is equal to

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Klein’s construction for determining the acceleration of piston P is shown in the given figure.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding the differential of an automobile

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

A single epicyclic gear train is shown in the given figure.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

In involute gears the pressure angle is

asked Dec 14, 2017 in tom by chandu (215k points)

Page:

« prev
1
...
11
12
13
14
15
16
17
18
19
...
50
next »

...