Recent questions tagged tom

0 votes

0 answers

Which one of the following can completely balance several masses revolving in different planes on a shaft?

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

For a twin cylinder V-engine, the crank positions for primary reverse cranks and secondary direct cranks are given

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The common practice is to balanced two-thirds of the reciprocating parts.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

If a rotor is dynamically balanced

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The number of turns made by the smaller gear for one revolution of the arm about the centre of the bigger gear is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The torque on A is 50 kN m (clockwise), C is a fixed shaft. The torque needed to fix C is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

In the case of gears of involute profiles, increase in the centre to centre distances between the mounting shafts

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Motor vehicles have differential gear mechanism at the back axle.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Two non-intersecting and non-parallel, i.e., non-coplanar, shafts connected

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The arm contains the bearings for the epicyclic gear to

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

For commercially cut gears, the limiting pitch line velocity is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The number of revolutions made by B is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider two shafts connected with two gears as per the following options:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding gear tooth designing or gear drive.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

A gear of 28cm pitch circle diameter has 40 teeth. The circular pitch will nearly be

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Involute pinions can have any number of teeth.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

A planetary gear train is gear train having

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

In the case of involute gears in contact

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Pressure angle of involute gears does not exceed

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

During assembly, the centre distance has increased slightly. Then which of the following changes occur?

asked Dec 14, 2017 in tom by chandu (215k points)

Page:

« prev
1
...
7
8
9
10
11
12
13
14
15
...
50
next »

...