Recent questions tagged md

0 votes

0 answers

Why are antifriction bearings not used at very high speeds?

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Determine the coefficient of friction using McKee equation

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

What are extreme pressure lubricants? What are the main additives and how do they act?

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

What do you understand by basic static low rating of a bearing?

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Determine the pipe size for (i) oil inlet if the maximum velocity of flow is 1.25 m/sec and (ii) oil drain

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Select a suitable ball-bearing subjected to following loads:

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Calculate the time required to bring the output shaft to the rated speed from rest.

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Find the required axial force to develop a maximum pressure of 0.65 MPa.

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Sketch and explain the working of centrifugal clutch give one application of it.

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Determine the mass of each shoe.

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Design dimensions of friction surfaces

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

what is the time needed to attain the full speed

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Calculate the power transmitting capacity of the clutch plate at 500 rpm using (i) uniform wear theory

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Determine the torque that can be transmitted by a single-plate clutch and the axial thrust.

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Determine the axial thrust to be provided by springs

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

What will be the maximum torque that the welded joint can sustain if the permissible shear stress

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

List two temporary fasteners and explain the working of one of these.

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Determine the size of the weld required for static loading in the eccentrically loaded weld as show in the figure below

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

Suggest most suitable and cheapest material for the following

asked Nov 13, 2017 in MD by chandu (215k points)

0 votes

0 answers

What will be the maximum torque that the welded joint can sustain if the permissible shear stress

asked Nov 13, 2017 in MD by chandu (215k points)

Page:

« prev
1
...
20
21
22
23
24
25
26
27
28
...
32
next »

...