Recent questions tagged iasprelims

0 votes

0 answers

Examine the figure shown below where in the numbers indicate the links:

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Match List – I (Hardness Test) with List – II (Measure of Hardness)

asked Oct 6, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

What is the radius of gyration of the column section?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Match List – I (Mechanical Property) with List – II (Mechanical Test)

asked Oct 6, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

What should be the minimum thickness of pipe if the maximum stress is not to exceed 80 N/mm2?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Which one of the following statements is correct?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

If the load at the end is increased where will the failure occur?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

What diameter should the driving pulley have on which a rubber belt runs so that bending stress in belt

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Which point(s) will have maximum stress?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Using the Prandtl’s mixing length concept how is the turbulent shear stress expressed?

asked Oct 5, 2017 in FM&Compressible by chandu (215k points)

0 votes

0 answers

How is the Von – Karman momentum integral equation expressed ( is momentum thickness)?

asked Oct 5, 2017 in FM&Compressible by chandu (215k points)

0 votes

0 answers

In a simple impulse turbine the nozzle angle at the entrance is 300. What is the blade speed ratio for maximum diagram?

asked Oct 5, 2017 in power-plant by chandu (215k points)

0 votes

1 answer

What is the cause of reheat factor in a steam turbine?

asked Oct 5, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

Consider the following statements

asked Oct 5, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

Consider the following statements: A tube section diverging in the direction of fluid flow can be used as

asked Oct 5, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

What is/are the effect (s) of supersaturationin nozzle flow?

asked Oct 5, 2017 in RAC by chandu (215k points)

0 votes

0 answers

When the lower temperature is fixed how can the c.o.p of a refrigerating machine be improved?

asked Oct 4, 2017 in RAC by chandu (215k points)

0 votes

0 answers

A Bell – Coleman air refrigeration system operates on which one of the following cycles?

asked Oct 4, 2017 in RAC by chandu (215k points)

0 votes

0 answers

What is the approximate value of the dryness fractions of the steam sample?

asked Oct 4, 2017 in RAC by chandu (215k points)

0 votes

0 answers

An Electrolux system of refrigeration has

asked Oct 4, 2017 in RAC by chandu (215k points)

Recent questions tagged iasprelims

Categories

Most popular tags