Recent questions tagged 2016

0 votes

0 answers

What is the factor of safety using maximum shear stress theory?

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The life of the bearing increases to

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The critical damping coefficient for the system is

asked Dec 18, 2017 in tom by chandu (215k points)

0 votes

0 answers

A governor is said to be hunting if the speed of the engine

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The distribution of mass along the axis of rotation of a shaft depends on

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The dynamic reactions at the supports will be

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

Motor vehicles have differential gear mechanism at the back axle.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Two non-intersecting and non-parallel, i.e., non-coplanar, shafts connected

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The arm contains the bearings for the epicyclic gear to

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

For commercially cut gears, the limiting pitch line velocity is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The number of revolutions made by B is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider two shafts connected with two gears as per the following options:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding gear tooth designing or gear drive.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

A gear of 28cm pitch circle diameter has 40 teeth. The circular pitch will nearly be

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

What is the coefficient of fluctuation of speed?

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The kinetic energy of the flywheel after 10 seconds from start is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The cam profile constructed using the principle of kinematic inversion

asked Dec 1, 2017 in tom by chandu (215k points)

0 votes

0 answers

A circular arc cam with a roller follower, acceleration of the follower depends on

asked Dec 1, 2017 in tom by chandu (215k points)

0 votes

0 answers

The length of the cutting stroke is

asked Nov 29, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which of the above can rightly be considered as successfully constrained motion?

asked Nov 29, 2017 in tom by chandu (215k points)

Page:

« prev
1
...
6
7
8
9
10
11
12
13
14
...
23
next »

...