Recent questions tagged 2016

0 votes

0 answers

Both sand and metal moulds can be used for

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

In shell moulding process, phenol formaldehyde is

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

The force required for a total combined deflection of 45 mm through the two springs is

asked Dec 22, 2017 in md by chandu (215k points)

0 votes

0 answers

The effect of stress concentration and of deflection in the spring , when the modulus of rigidity is 80 kN/mm2.

asked Dec 22, 2017 in md by chandu (215k points)

0 votes

0 answers

The equivalent stiffness of the two springs is.

asked Dec 22, 2017 in md by chandu (215k points)

0 votes

0 answers

What is the torque – transmitting capacity of the bolts to the nearest 10units?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The linear speed of the belt in a belt drive is controlled by the tensile strength of the materials of the driven pulley

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In case of design of friction clutches, uniform rate of wear theory is used over uniform pressure.

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Full-depth involute profile pinion with 20 teeth meshes with a gear that has 50 teeth for a module of 6mm?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

While selecting the elements of power transmission with speed reduction, the order of preference based on

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In an epicyclic gear train, the size of the gear box is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The problem of interference in involute profile gears can be overcome by which one of the following means?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The value of sommerfeld number is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The ultimate strength is MPa and the factor of safety is 3, will nearly be

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

the power that can be transmitted by the latter shaft is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The bearing modulus for a bearing is 1628. What is the bearing characteristic number considered for bearing design?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The diameter of the pin is a bushed pin type flexible coupling

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The required length of the key would be

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The permissible direct shear stress of the weld is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Endurance limit is of primary concern in the design of a/an

asked Dec 18, 2017 in md by chandu (215k points)

Page:

« prev
1
...
5
6
7
8
9
10
11
12
13
...
23
next »

...