Recent questions tagged 2002

0 votes

0 answers

The axis of cam rotation?

asked Nov 27, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine the stiffness and initial compression of the spring

asked Nov 26, 2017 in tom by chandu (215k points)

0 votes

0 answers

Determine the angular position of each mass with respect to C

asked Nov 26, 2017 in tom by chandu (215k points)

0 votes

0 answers

To what value should the pressure angle be increased in order to eliminate the interference?

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which principle reduces the problem of kinematics to equivalent problem of statics?

asked Nov 24, 2017 in tom by chandu (215k points)

+1 vote

1 answer

What is the magnitude of coriolis acceleration for a slider sliding at 10 cm/sec.

asked Nov 24, 2017 in tom by chandu (215k points)

0 votes

0 answers

What is the difference in the analysis of thick tubes compared to that for thin tubes?

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the maximum tensile stress in the beam and indicate where it occurs

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Which one will deflect more and why?

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Find also the magnitude of the other principal stress at this point.

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

List the different methods suitable for making through holes of diameter around 4 mm in a 2 mm thick glass plate.

asked Nov 21, 2017 in production by chandu (215k points)

0 votes

0 answers

What do you understand by the term anisotropy ?

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

0 answers

How much force will be required to pierce a circular hole

asked Nov 20, 2017 in production by chandu (215k points)

0 votes

1 answer

Name the instruments by which diameter of machined circular holes

asked Nov 19, 2017 in production by chandu (215k points)

0 votes

0 answers

What are the relative advantages of submerged arc welding over conventional open air manual arc welding and why?

asked Nov 19, 2017 in production by chandu (215k points)

0 votes

0 answers

How is the wax pattern made for an investment casting and why is the master pattern made oversize?