Recent questions tagged 2002

0 votes

0 answers

The bolts in a rigid flanged coupling connecting two shats transmitting power are subjected to

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The factor of safety of the design is

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The displacement of the shaft at a speed which is 90% of critical speed in microns is

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

The distance of node from the rotor of lower moment of inertia is

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

The mass of the rod is ‘m’ and length ‘l’ the natural frequency of this rod in Hz for small amplitude is

asked Dec 16, 2017 in tom by chandu (215k points)

0 votes

0 answers

Neglecting obliquity and gravitational effects, the lift of the sleeve is

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which of the following is an isochronous governor?

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements for completely balancing a single rotating mass

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The torque to fix C

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements: A stub tooth system is generally preferred in spur gears as it results in

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The dynamic load on a gear is due to

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements in case of reverted gear train:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Then energy stored in the latter at the same speed will be

asked Dec 13, 2017 in tom by chandu (215k points)

0 votes

0 answers

The quick return ratio of the mechanism is

asked Dec 1, 2017 in tom by chandu (215k points)

0 votes

0 answers

The instantaneous centre of rotation of a rigid thin disc rolling without slip on a plane rigid surface is located at

asked Dec 1, 2017 in tom by chandu (215k points)

0 votes

0 answers

The speed of rotation of the cam should not exceed

asked Dec 1, 2017 in tom by chandu (215k points)

0 votes

0 answers

For high speed cam follower is

asked Dec 1, 2017 in tom by chandu (215k points)

0 votes

0 answers

The degrees of freedom of the linkage when link ABC is fixed are

asked Nov 29, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List I (Mechanism) with List II(Motion) and select the

asked Nov 29, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List I(Kinematic pairs) with List II(Practical example) and select the correct answer:

asked Nov 29, 2017 in tom by chandu (215k points)

Page:

« prev
1
...
5
6
7
8
9
10
11
12
13
...
22
next »

...