Recent questions tagged 1999

0 votes

0 answers

Consider the following approaches normally applied for the economic analysis of machining

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

If the cutting speed is halved the toll life will increase by

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of the following sets of forces are encountered by a lathe parting tool while groove cutting

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The correct sequence of the given processes is manufacturing by powder metallurgy is

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The correct sequence of the given materials in ascending order of their weldability is

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In sheet metal blanking operation, clearance must be given to the die.

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Earring in a drawn cup can be due to non – uniform

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

In a two high rolling mill there is a limit to the possible reduction in thickness in one pass.

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of the following is the correct temperature range for hot extrusion of aluminum?

asked Dec 22, 2017 in production by chandu (215k points)

+1 vote

0 answers

Consider the following operations involved in forging a hexagonal bolt

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

(a) Drawing (b) Rolling (c) Wire drawing (d)Sheet metal operations using progressive dies

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

In solidification of metal during casting, compensation for solid contraction is

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Two equal parts and the parts are then used in parallel the ratio of the spring rate to its initial value will be

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In a close – coiled helical spring the maximum shea stress occurs on the

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The stiffness of the second spring will be

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following screw thread is adopted for power transmission in either direction?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The diameter of tommy bar for a screw jack is designed for

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Different type of detachable joints) with List – II (Specific use of these detachable joints)

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Centrifugal tension in belts is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In case of friction clutches, uniform wear theory should be considered for power transmission calculation

asked Dec 20, 2017 in md by chandu (215k points)

Page:

« prev
1
...
4
5
6
7
8
9
10
11
12
...
19
next »

...