Recent questions tagged 1999

0 votes

0 answers

Gibb’s phase rule is given by

asked Dec 26, 2017 in material science by chandu (215k points)

0 votes

0 answers

Match List – I (Crystal structure) with List – II (Atomic packing factor)

asked Dec 26, 2017 in material science by chandu (215k points)

0 votes

0 answers

If permissible stress in plates of joint through a pin as shown in the figure is 200 Mpa then the width will be

asked Dec 26, 2017 in som by chandu (215k points)

0 votes

0 answers

In atomization process of manufacture of metal powder,

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following processes for the manufacture of gears

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

(A) Die sinking (B) Deburring (C) Fine hole drilling (thin materials)

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding numerically controlled machine tools

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

Transfer machines can be defined as

asked Dec 25, 2017 in production by chandu (215k points)

0 votes

0 answers

Spherical washers are used to locate the job in the

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Diamond pin location is used in a fixture because

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The index change gear ratio is governed by which one of the following kinematic balance equations?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding reaming process

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of the following processes results in the best accuracy of the hole made?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List –I (Drill bits) with List – II (Applications)

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following reasons

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The feed per tooth in this operation will be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The radial force in single – point tool during turning operation varies between

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

To keep the same level of surface finish the nose radius of the tool should be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

For prescision machining of non – ferrous alloys, diamond is preferred because is has

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List – I (ISO classification of carbide tools) with List – II (Applications)

asked Dec 24, 2017 in production by chandu (215k points)

Page:

« prev
1
...
3
4
5
6
7
8
9
10
11
...
19
next »

...