Recent questions tagged 1994

0 votes

0 answers

Non-ferrous materials are best machined with

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Cubic boron nitride is used

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The ratio of thrust force to cutting force is nearly 2.5 in

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The correct sequence of these tool materials in increasing order of the their ability to retain their hot hardness is

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Tool geometry of a single point cutting tool is specified by the following elements:

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

What is the correct sequence of the following parameters in order of their maximum to minimum influence on tool life?

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The following parameters determine the model of continuous chip formation :

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The electrodes of AC arc welding are coated with sodium silicate, whereas electrodes used for

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

(a) Cu, Zn, Ag alloy (b) Cu, Sn alloy (c) Pb, Sn alloy

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of following welding processes uses non-consumable electrodes?

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Inert gas and bare electrode instead of flux coated electrode is used in the case of

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

For obtaining a cup of diameter 25 m and height 15 mm by drawing the size of the round blank should be approximately

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

In sheet metal blanking shear is provided on punches and dies so that

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Metal extrusion process is generally used for producing

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

In drop forging, forging is done by dropping

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Which of the following pairs of process and draft are correctly matched?

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List I (Metal forming process) with List II(A similar process)

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Which of the following materials can be used for making patterns?

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

In a mould, a riser is designed and placed so that the riser will solidify after the casting has solidified

asked Dec 22, 2017 in production by chandu (215k points)

0 votes

0 answers

Cracks in helical springs used in Railway carriages usually start on the inner side of the coil because of

asked Dec 21, 2017 in md by chandu (215k points)

Recent questions tagged 1994

Categories

Most popular tags