Recent questions in IES Objectives-2

0 votes

0 answers

Match List – I with List – II and select the correct answer using codes given below the lists:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

When two gears are meshing, the clearance is given by the

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Helical gears are used for transmitting motion and power between intersecting shafts

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following pairs of parts:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The speed ratio in the case of compound train of wheels is equal to

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding the choice of conjugate teeth for the profiles of mating gears:

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

A pinion of pressure angle and 48 in volute teeth has a pitch circle diameter of 28.8 cm. it has

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

When two shafts are neither parallel nor intersecting, power can be transmitted by using

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

These characteristics which are applicable to stub in volute system would include

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The working surface above the pitch surface of the gear tooth is termed as

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The torque which must be applied to A will be

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

If the arm C makes three revolutions the number of revolutions made by B will be

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

In the case of an involute toothed gear involute starts from

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

A reverted gear train is one in which the output shaft and input shaft

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List – I (Positioning of two shafts) with List – II (Possible connection)

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Epicyclic gear trains

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Overall speed ratio of the train is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

If both have the same size of addendum, then there will be an interference between the

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The number of turns made by the smaller gear for one revolution of arm about the centre of the bigger gear is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Match List – I with List – II and select the correct answer using the codes given below the lists:

asked Dec 14, 2017 in tom by chandu (215k points)

Page:

« prev
1
...
128
129
130
131
132
133
134
135
136
...
142
next »

Recent questions in IES Objectives-2

...