Recent questions in IES Objectives-2

0 votes

0 answers

Which one of the following equations should be satisfied for primary force balance?

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The total dynamic reactions at the supports will be

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

The secondary reverse crank for balancing will be at

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

A system of masses rotating in different parallel planes is in dynamic balance if the resultant

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

In the statement “an eccentric mass rotating at 3000 rpm will create X times more unbalanced force

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

A rotor supported at A and B, carries two masses as shown in the given figure. The rotor is

asked Dec 15, 2017 in tom by chandu (215k points)

0 votes

0 answers

Consider the following statements regarding a high speed in line engine with identical reciprocating parts

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

At the same rotor speed, dynamic reaction on the left bearing in the new arrangement will

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

For the rigid body to be in equilibrium

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Which one of the following can completely balance several masses revolving in different planes on a shaft?

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

For a twin cylinder V-engine, the crank positions for primary reverse cranks and secondary direct cranks are given

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The common practice is to balanced two-thirds of the reciprocating parts.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

If a rotor is dynamically balanced

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The number of turns made by the smaller gear for one revolution of the arm about the centre of the bigger gear is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The torque on A is 50 kN m (clockwise), C is a fixed shaft. The torque needed to fix C is

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

In the case of gears of involute profiles, increase in the centre to centre distances between the mounting shafts

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Motor vehicles have differential gear mechanism at the back axle.

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

Two non-intersecting and non-parallel, i.e., non-coplanar, shafts connected

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

The arm contains the bearings for the epicyclic gear to

asked Dec 14, 2017 in tom by chandu (215k points)

0 votes

0 answers

For commercially cut gears, the limiting pitch line velocity is

asked Dec 14, 2017 in tom by chandu (215k points)

Page:

« prev
1
...
124
125
126
127
128
129
130
131
132
...
142
next »

Recent questions in IES Objectives-2

...