Recent questions in md

0 votes

0 answers

Centrifugal tension in belts is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following stresses are associated with design of pins in bushed pin – type flexible coupling?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

When the shafts are neither parallel nor intersecting, power can be transmitted by using

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The initial tension of the belt taking centrifugal tension is equal to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

the belt would tend hang clear of the lower pulley when

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The virtual coefficient of friction will

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

It is desirable to increase the length of arc over which the oil film has to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

When belt drive is transmitting maximum power

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The velocity ratio of the drive will be

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The maximum power can be transmitted when the centrifugal tension is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Different type of detachable joints) with List – II (Specific use of detachable joints)

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Sources of power loss in a chain drive are given below:

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Oldham coupling is used to transmit power between two parallel shafts which are slightly offset

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

A device used for lifting of lowering objects suspended from a hook at the end of retractable chains or cable is called

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

When compared to a rod of the same diameter and material, wire rope

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The length or chain in terms of pitches can be approximated by

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In a short centre open-belt drive, and idler pulley is used to maintain the belt tension and to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The following data refers to an open belt drive

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Regarding the power transmitted by a clutch, greater the speed, lower the torque to

asked Dec 21, 2017 in md by chandu (215k points)

Page:

« prev
1
...
3
4
5
6
7
8
9
10
11
...
21
next »

Recent questions in md

...