Recent questions in md

0 votes

0 answers

Match List-I (Application) with List-II (joint)

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Part to be joined) with List-II (Type of joint)

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In a gib and cotter joint, the gib and cotter are subjected to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In case of belt drive, the effect of the centrifugal tension is to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Crowing is provided on the surface of a flat pulley to prevent slipping of the belt sideways

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following statements in respect of flexible couplings.

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

What is the shearing stress developed ion the cotter?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The piston rod and the crosshead in a steam engine are usually connected by means of

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

A cotter joint is used when no relative motion is permitted between the rods joined by the cotter

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The length of the belt in the case of a cross-belt drive is given in terms of

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The maximum power can be transmitted when the centrifugal tension is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List –I (Coupling) with List –II (Purpose) codes given below this:

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

which one of the following equations will give the diameter of the spigot?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In design of arms of pulley, in belt drive, the cross – section of the arm is elliptical with minor axis placed

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

For similar materials having the same maximum permissible tensile, V – belt transmits more power than

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The creep in a belt drive is due to the

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Which one of the following statements with regard to belt drives is NOT correct?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following stresses are associated with the design of pins in bushed pin – type, flexible coupling?

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Application) with List – II (Drive element)

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Different type of detachable joints) with List – II (Specific use of these detachable joints)

asked Dec 21, 2017 in md by chandu (215k points)

Page:

« prev
1
2
3
4
5
6
7
8
9
10
...
21
next »

Recent questions in md

...