Recent questions in IES Conventional-2

0 votes

0 answers

Why is an I-section preferred over a solid rectangular section for use as a beam section?

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Determine the ratio of maximum stresses in the two cases.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Determine : (i) reactions at ends. (ii) bending moment at section where SF is zero.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Draw the bending moment diagram of the cantilever.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Draw the variations of ‘SF’ and ‘BM’ in both the cases.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Draw the variations of ‘SF’ and ‘BM’ in both the cases.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

What is meant by point of contra flexure or point of inflection in a beam? Show the same for the beam given below:

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

What would be the maximum bending moment and where does it occur?

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the reactions R1 and R2 and draw the shear force and bending moment diagrams.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Construct the bending moment and shearing force diagrams for the beam shown in Fig.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Draw the Shear Force and Bending Moment diagrams.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Plot the bending moment and shear force diagrams indicating the principal values.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Determine the principal stresses and the positions of the planes on which they act

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

The maximum shearing stress in magnitude and direction

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the values of principal stresses acting at the point and their directions.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

What is the magnitude of the maximum shear stress?

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

The Mohr’s circle

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

What are the magnitudes of these stresses?

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

Find also the magnitude of the other principal stress at this point.

asked Nov 21, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the normal and shear stresses on the plane of maximum shear stress.

asked Nov 21, 2017 in som by chandu (215k points)

Page:

« prev
1
...
8
9
10
11
12
13
14
15
16
...
54
next »

Recent questions in IES Conventional-2

...