Recent questions in IES Conventional-2

0 votes

0 answers

Why more than one full length leaves are provided in a leaf spring?

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Differentiate between a closed coiled and an open coiled helical spring.

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

In leaf springs for automobiles a number of thin strips are used. Why do not we use a single thick strip?

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

What is the significance of Whal’s correction factor?

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Find the maximum shear stress and the deflection

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Determine also the deflection in the spring

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Find the minimum values of breadth and depth if the maximum bending stress

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the vertical deflection of the lower end if the ring is of rectangular cross-section

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Find the slope and deflection at the free end of a cantilever beam of length 6m as loaded shown in figure

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the maximum tensile stress in the beam and indicate where it occurs

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Which one will deflect more and why?

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

What would be its slope at the (i) free end (ii) built-in end?

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Derive an expression for bending deflection at the free end.

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Compare its free end deflection under the following two conditions:

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the maximum deflection for the loading.

asked Nov 23, 2017 in som by chandu (215k points)

0 votes

0 answers

Calculate the diameter of the latter

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Determine angular twist between A to C.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

Find the values of (i) Modulus of rigidity, (ii) Poisson’s ratio.

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

What is the ratio of maximum shear stress in the hollow shaft to that of solid shaft?

asked Nov 22, 2017 in som by chandu (215k points)

0 votes

0 answers

What percent saving in weight would be obtained if this shaft

asked Nov 22, 2017 in som by chandu (215k points)

Page:

« prev
1
...
6
7
8
9
10
11
12
13
14
...
54
next »

Recent questions in IES Conventional-2

...