Recent questions in IAS Prelims

0 votes

0 answers

Match List – I (Gear Train) with List – II (Application)

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Examine the figure shown below where in the numbers indicate the links:

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Match List – I (Hardness Test) with List – II (Measure of Hardness)

asked Oct 6, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

What is the radius of gyration of the column section?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Match List – I (Mechanical Property) with List – II (Mechanical Test)

asked Oct 6, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

What should be the minimum thickness of pipe if the maximum stress is not to exceed 80 N/mm2?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Which one of the following statements is correct?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

If the load at the end is increased where will the failure occur?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

What diameter should the driving pulley have on which a rubber belt runs so that bending stress in belt

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Which point(s) will have maximum stress?

asked Oct 6, 2017 in SOM&MD by chandu (215k points)

0 votes

0 answers

Using the Prandtl’s mixing length concept how is the turbulent shear stress expressed?

asked Oct 5, 2017 in FM&Compressible by chandu (215k points)

0 votes

0 answers

How is the Von – Karman momentum integral equation expressed ( is momentum thickness)?

asked Oct 5, 2017 in FM&Compressible by chandu (215k points)

0 votes

0 answers

In a simple impulse turbine the nozzle angle at the entrance is 300. What is the blade speed ratio for maximum diagram?

asked Oct 5, 2017 in power-plant by chandu (215k points)

0 votes

1 answer

What is the cause of reheat factor in a steam turbine?

asked Oct 5, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

Consider the following statements

asked Oct 5, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

Consider the following statements: A tube section diverging in the direction of fluid flow can be used as

asked Oct 5, 2017 in power-plant by chandu (215k points)

0 votes

0 answers

What is/are the effect (s) of supersaturationin nozzle flow?

asked Oct 5, 2017 in RAC by chandu (215k points)

0 votes

0 answers

When the lower temperature is fixed how can the c.o.p of a refrigerating machine be improved?

asked Oct 4, 2017 in RAC by chandu (215k points)

0 votes

0 answers

A Bell – Coleman air refrigeration system operates on which one of the following cycles?

asked Oct 4, 2017 in RAC by chandu (215k points)

0 votes

0 answers

What is the approximate value of the dryness fractions of the steam sample?

asked Oct 4, 2017 in RAC by chandu (215k points)

Recent questions in IAS Prelims

Categories

Most popular tags