Recent questions in GATE

0 votes

0 answers

find the ratio given below

asked Aug 13, 2017 in SOM by chandu (215k points)

0 votes

0 answers

doubled – parallelogram mechanism

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

3 answers

stress in the bar

asked Aug 13, 2017 in SOM by chandu (215k points)

0 votes

0 answers

Grashof’s rule

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

find out the correct observation

asked Aug 13, 2017 in SOM by chandu (215k points)

0 votes

0 answers

The relative velocity between the two points

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Mobility of a statically indeterminate structure is

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The number of degrees of freedom of the mechanism

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The number of inversions for a slider crank mechanism is

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

For a four bar linkage in Toggle position, the value of mechanical advantage is

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The number of degrees of freedom of a planner linkage with 8 links and 9 simple revolute joints is

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

find out the distance between crank centre to lever centre point

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The mechanical advantage for the given configuration is ?

asked Aug 13, 2017 in TOM by chandu (215k points)

0 votes

0 answers

analysis of double crank mechanism

asked Aug 12, 2017 in TOM by chandu (215k points)

0 votes

0 answers

mechanism used in shaping machines

asked Aug 12, 2017 in TOM by chandu (215k points)

0 votes

1 answer

horizontal milling process - surface finish and tool life

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

1 answer

composition of 1% plain carbon steel after cooling from molten state to 740 C

asked Aug 12, 2017 in Material Science by chandu (215k points)

0 votes

0 answers

machines used for small lot production of T-slots

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

equation of longitudinal feed in center-less grinding

asked Aug 12, 2017 in production by chandu (215k points)

0 votes

0 answers

finishing of cylinder bores of automobile engines

asked Aug 12, 2017 in production by chandu (215k points)

Categories

Most popular tags