Recent questions in Engg Mechanics

0 votes

0 answers

The maximum value of acceleration (in m/s2) of the truck such that the crate does not slide down is ________

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

The velocity (in m/s) of the block

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

The minimum force F (in kN) needed to move the block S is

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

0 answers

A pin jointed uniform rigid rod of weight W and length L is supported horizontally by an external force F

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

All the joints are hinged

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

The friction force is

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

A uniform rigid rod of mass M and length L is hinged at one end as shown in the below figure

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

Consider a true PQR loaded at P with a force F as shown in the figure. the tension in the member QR is

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

The magnitude of the velocity at point ‘P’ (see figure) is

asked Aug 27, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

A block of mass M is released from point P on a rough inclined plane with inclination angle $\Theta$.

asked Aug 26, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

If point a is in equilibrium under the action of the applied forces

asked Aug 26, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

Assuming that the wheel and the ground are both rigid and that the wheel is set into pure rolling motion

asked Aug 26, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

The minimum value of F for which slip occurs between the two books is

asked Aug 25, 2017 in Engg Mechanics by chandu (215k points)

0 votes

0 answers

An elevator (lift) consists of the elevator cage and a counter weight

asked Aug 25, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

The magnitude of the absolute velocity of the shell is

asked Aug 24, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

. The percentage increase in mass moment of inertia as a result of this addition is

asked Aug 23, 2017 in Engg Mechanics by chandu (215k points)

0 votes

0 answers

An ejector mechanism consist of a helical compression spring

asked Aug 23, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

The figure below shown a pair of pin jointed gripper tongs holding

asked Aug 23, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

Data questions 1 and 2

asked Aug 23, 2017 in Engg Mechanics by chandu (215k points)

0 votes

1 answer

what is the apparent velocity

asked Aug 23, 2017 in Engg Mechanics by chandu (215k points)

Page:

Recent questions in Engg Mechanics

...