A hole and a shaft have a basic size of 25 mm, and are to have a clearance fit with a maximum clearance of 0.02 mm and a minimum clearance of 0.01 mm. The hole tolerance is to be 1.5 times the shaft tolerance. The limits of both hole and shaft using hole basis system will be
(a) low limit of hole = 25mm, high limit of hole = 25.006 mm, upper limit of shaft = 24.99 mm and low limit of shaft = 24.986 mm
(b) low limit of hole = 25mm, high limit of hole = 25.026 mm, upper limit of shaft = 24.8 mm and low limit of shaft = 24.76 mm
(c) low limit of hole = 24 mm, high limit of hole = 25.006 mm, upper limit of shaft = 25mm and low limit of shaft = 24.99 mm
(d) low limit of hole = 25.006 mm, high limit of hole= 25 mm, upper limit of shaft =24.99 mm and low limit of shaft = 25mm.