0 votes
34 views
asked in production by (215k points)
edited by

            A part program is to be written to drill the holes in the work part shown below. The part is 10mm thick. The dia of drill is  10.0.

(i)      Define the x and y axes for the job.

(ii)  Write manual part program

ming using word address format and an absolute position system. The words that must be specified for the particular drill press are n- x- y- and m-words. The speed and feed are manually set by the operator.

                                     

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...