0 votes
210 views
asked in production by (215k points)

A ϕ 40 mm job is subjected to orthogonal turning by a + 100 rake angle tool at 500 rev/min. By direct measurement during the cutting operation, the shear angle was found equal to 250

 

The velocity (in m/min) with which the chip flows on the tool face is

(a) 32             (b) 63            (c) 22                    (d) 27.5

If the friction angle t the tool-chip interface is 580 10’ and the cutting force components measured by a dynamometer are 600 N and 200 N, the power loss due to friction (in kNm/min) is approximately.

(a) 20        (b) 18         (c) 16         (d) 250

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...