0 votes
72 views
asked in production by (215k points)
A single point cutting tool with a nose radius of 0.4 mm was used to turn a component in a lathe employing a feed rate of 0.3 mm/rev. if the feed-rate is doubled the ideal surface roughness (peak-to-valley height) produced on the component will increase by a factor of

(a) 2             (b) 4               (c) 8                (d) 16

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...