0 votes
63 views
asked in production by (215k points)
In idealized chip formation, built up edge will break off and remove some of the cutting tool materials, thereby reducing tool life. Which of the following steps prevent built up edge?

         1. Increasing cutting speed

         2. Increasing feed rate

         3. Increasing ambient work – piece temperature

         4. Decreasing rake angle

         5. Reducing friction

         Select the correct answer using the code given below:

         (a) 1, 2 and 3                  (b) 2, 3 and 4

         (c) 1, 3 and 5                  (d) 2, 4 and 5

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...