0 votes
227 views
asked in SOM&MD by (215k points)
edited by

A circle of 100 mm diameter is inscribed on a steel plate before it is stressed. Then the plate is loaded so as to produce stresses as shown in the above figure and the circle is deformed into an ellipse. Determine the lengths of major and minor axes of the ellipse and their directions. Take modulus of elasticity of steel as 2.1 MN/cm2 and Poisson’s ratio 0.28.     

Please log in or register to answer this question.

Welcome to Q&A discussion forum, where you can ask questions and receive answers from other members of the community.

10.4k questions

274 answers

26 comments

15.3k users

...