Recent activity by chandu

0 answers

A steel rod of cross-sectional area 10 mm2 is subjected to loads at points P,Q,R and S as shown in the figure below:

edited Jul 14, 2020 in som

1 answer

Name the instruments by which diameter of machined circular holes

answered Jul 8, 2019 in production

1 answer

Linear programming, Queueing and Dynamic problem

edited May 28, 2019 in im&or

1 answer

What is the mean effective pressure?

answer reshown Oct 27, 2018 in IC Engines

2 answers

The component of torque converter that allows torque multiplication is

answer reshown Oct 27, 2018 in FM

0 answers

If the load on a ball bearing is reduced to one third, then its life would increase by:

comment reshown Oct 27, 2018 in md

1 answer

Write short notes on Interference and undercutting in Involute gears.

answer reshown Oct 27, 2018 in tom

0 answers

Calculate the rate of heat gain by the refrigerator surface.

comment reshown Oct 27, 2018 in HT

0 answers

Determine the temperature of the outer wall.

reshown Oct 27, 2018 in HT

0 answers

Determine the temperature of the outer wall.

reshown Oct 27, 2018 in HT

0 answers

circular banks of 35mm diameter are punched from a steel sheet of 2mm

asked Oct 6, 2018 in FM

0 answers

Circular banks of 35mm diameter

asked Oct 6, 2018 in FM

0 answers

A Disc of 200 mm

asked Oct 5, 2018

0 answers

A disc 0f 200 mm

asked Oct 5, 2018 in production

0 answers

A rectangular hole of size 100 mm

asked Oct 5, 2018 in production

0 answers

Arectangular hole of size 100

asked Oct 5, 2018 in production

0 answers

A thermodynamic cycle

edited Sep 26, 2018 in TD

0 answers

The velocity of the belt for maximum power transmission is

edited Sep 26, 2018 in md

0 answers

The turbomachine is

edited Sep 26, 2018 in PPE

0 answers

The turbo machine is

edited Sep 26, 2018 in PPE

...