Recent questions without a selected answer

0 votes

0 answers

Uniform strength bolts are used for resisting impact loads

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The following two figure show welded joints (XXX indicated welds)

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List-I (Types of joints) and List – II (An element of the joint)

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Which one of the following structural joints with 10 rivets and same size of plate and material will be most efficient?

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The most efficient riveted joint possible is one which would be as strong in tension, shear an bearing as

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Type of Joints) and List –II (Made of Joining members)

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The frictional torque for square thread at mean radius while raising load is given be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The frictional torque for square thread at mean radius while raising load is given be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The frictional torque for square thread at mean radius while raising load is given be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

The frictional torque for square thread at mean radius while raising load is given be

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

In a flat collar pivot bearing, the moment due to friction is proportional to

asked Dec 19, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following stresses are associated with the tightening of a nut on a stud?

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following is true about following specifications Hex Bolt M 16NL-IS:1363

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The ideal material for shafts transmitting power is

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The value of the minimum ultimate strength according to modified Goodman relation will be

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

For a component made of ductile material, the failure criterion will be

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

Endurance limit is of primary concern in the design of a/an

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

What is the factor of safety using maximum shear stress theory?

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

The life of the bearing increases to

asked Dec 18, 2017 in md by chandu (215k points)

0 votes

0 answers

In the design of connecting rod small end bearing, the value of permissible bearing pressure to be used is:

asked Dec 18, 2017 in md by chandu (215k points)

Page:

« prev
1
...
206
207
208
209
210
211
212
213
214
...
520
next »

...