Recent questions without a selected answer

0 votes

0 answers

The ultimate strength is MPa and the factor of safety is 3, will nearly be

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

the power that can be transmitted by the latter shaft is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The bearing modulus for a bearing is 1628. What is the bearing characteristic number considered for bearing design?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The diameter of the pin is a bushed pin type flexible coupling

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

If the equivalent load in case of radial ball bearing is 500N and the basic dynamic load rating is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider the following statements in connection with thrust bearings:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider that modern machines mostly use short bearings due to the following reasons:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The torque that can be transmitted by A is.

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The sunk key will be equally strong in shearing and crushing if the key is a

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The bearing suitable for supporting such a shaft is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

When a shaft rotates anti-clockwise direction at high speed in a bearing, it will

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The necessary length of the key for equal shear strength of shaft and key will be

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The journal while rotating inside a bearing automatically shifts its center to one side and thus the journal is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Removal of metal particles from the race-way of bearing, known is

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

If the load on a ball bearing is reduced to one third, then its life would increase by:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The bearing characteristic number depends on :

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In case of hydrodynamic lubrication in a journey bearing the attitude is the ratio of:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

The basic reason why shafts are made of steel and its alloys is:

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

Which of the following is a joint formed by interference fits?

asked Dec 20, 2017 in md by chandu (215k points)

0 votes

0 answers

In the assembly of pulley, key and shaft:

asked Dec 20, 2017 in md by chandu (215k points)

Page:

« prev
1
...
198
199
200
201
202
203
204
205
206
...
520
next »

...