Recent questions without a selected answer

0 votes

0 answers

The maximum power can be transmitted when the centrifugal tension is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Match List – I (Different type of detachable joints) with List – II (Specific use of detachable joints)

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Sources of power loss in a chain drive are given below:

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Oldham coupling is used to transmit power between two parallel shafts which are slightly offset

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

A device used for lifting of lowering objects suspended from a hook at the end of retractable chains or cable is called

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

When compared to a rod of the same diameter and material, wire rope

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The length or chain in terms of pitches can be approximated by

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In a short centre open-belt drive, and idler pulley is used to maintain the belt tension and to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The following data refers to an open belt drive

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In a belt drive, if the pulley diameter is doubled keeping the tension and belt width constant

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Regarding the power transmitted by a clutch, greater the speed, lower the torque to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In case of design of friction clutches, uniform rate of wear theory is used over uniform pressure.

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Centrifugal clutches are designed to provide automatic and sooth engagement of load to

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

Consider that a wire rope is subjected to the following stresses

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The reduction in torque due to friction (Assuming uniform rate of wear) is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

A rope has been designated as 6x9. The numbers 6 and 19 respectively stand for

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The effect of increasing the stiffness of springs of centrifugal clutch is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

the torque transmitted (assuming uniform wear) is

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

The number of pairs contact surface is.

asked Dec 21, 2017 in md by chandu (215k points)

0 votes

0 answers

In design of friction clutches the torque transmission capacity is

asked Dec 21, 2017 in md by chandu (215k points)

Page:

« prev
1
...
194
195
196
197
198
199
200
201
202
...
520
next »

...