Recent questions without a selected answer

0 votes

0 answers

Which of the following indicate better machinability?

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of the following tool material will be suitable for machining the component under the specified cutting ?

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Chip equivalent is increased by

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

If the diameter of the hole is subject to considerable variation, then for locating in

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List – I (Task) with List – II (Recommendation)

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

While cutting helical gears on a non – differential gear hobber, the feed change gear ratio is

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In a mechanical shaper, the length of stroke is increased by

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In a Swiss – type automatic lathe, the turret is given longitudinal feed for each tool in a specific order with

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Soft material cannot be economically grounded due to

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In the grinding wheel of A60 G7 B23, B stands for

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

In a milling operation two side milling cutters are

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Up milling or climb is commonly used for

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The effects of setting a boring tool above centre height leads to a/an

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The primary tool force used in calculating the total power consumption in machining is the

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following work materials:

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Crater wear is predominant in

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The straight grades of cemented carbide cutting tool material contain

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statements about nose radius

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

Single point theread cutting tool should ideally have

asked Dec 23, 2017 in production by chandu (215k points)

0 votes

0 answers

The angle between the face and the flank of the single point cutting tool is known as

asked Dec 23, 2017 in production by chandu (215k points)

Recent questions without a selected answer

Categories

Most popular tags