Recent questions without a selected answer

0 votes

0 answers

Match List –I (Drill bits) with List – II (Applications)

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following reasons

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The feed per tooth in this operation will be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The radial force in single – point tool during turning operation varies between

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

To keep the same level of surface finish the nose radius of the tool should be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

For prescision machining of non – ferrous alloys, diamond is preferred because is has

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Match List – I (ISO classification of carbide tools) with List – II (Applications)

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following approaches normally applied for the economic analysis of machining

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

If the cutting speed is halved the toll life will increase by

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of the following sets of forces are encountered by a lathe parting tool while groove cutting

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Internal gears are cut on agear shaper

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which of the following statement about the reamer size are correct?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

(A) Reaming (B) Counter - boring (C) Counter - sinking

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The tailstock offsetrequired to produce this taper on a lathee would be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The gauge factor of a resistive pick – up of cutting force dynamometer is defined as the ratio of

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of the following pairs of parameters and effects is not correctly matched?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which of the following motions are not needed for spur gear cutting with a hob?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following operations

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which of the following are the advantages of a hydraulic shaper over a mechanically driven shaper?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which one of the following materials is used as the bonding material for grinding wheels?

asked Dec 24, 2017 in production by chandu (215k points)

Recent questions without a selected answer

Categories

Most popular tags