Recent questions without a selected answer

0 votes

0 answers

Process capability of machine is defined as the capability of the machine to

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

A diamond locating pin is used in jigs and fixtures because

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

When supported on three points, out of the 12 degrees of freedom the number of degrees of freedom arrested in a body is

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The floating position of holding fixture in a rotary transfer device is used to

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Electron beam welding can be carried out in

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Which of the above parameters will influence the axial feed rate in centre-less grinding?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Consider the following statements for down – milling operation:

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The complexity of a jig or a fixture is determined by

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

During the information of chips in machining with a cutting tool, which one of the following relations holds good?

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The values of n and C are

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

Flank wear occurs mainly on the

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

If the speeds are in geometric progression, then the ratio is

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The cutting speed will be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The cutting force and the approximate value of torque at a spindle run of 120 r.p.m. will respectively be

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The feed in face milling for a width of 70 mm with a cutter of 160 mm diameter,

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

A 125 mm long, 10 mm diameter stainless steel rod is being turned to 9mm diameter, 0.5mm depth of cut.

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

A thick lubrication is

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The ceramic tools used in machining of material

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

For cutting multi-start threads, the speed ratio is expressed in terms of the lead of the job thread and lead of

asked Dec 24, 2017 in production by chandu (215k points)

0 votes

0 answers

The purpose of providing side rake angle on the cutting tool is to

asked Dec 24, 2017 in production by chandu (215k points)

Recent questions without a selected answer

Categories

Most popular tags