Recent questions tagged tom

0 votes

0 answers

The relative velocity of sliding in the teeth of gears in mesh is zero at?

asked Oct 7, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Which one of the following order of reduction is desirable?

asked Oct 7, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Transmission angle is the angle between

asked Oct 7, 2017 in TOM by chandu (215k points)

0 votes

0 answers

When is the chain locked?

asked Oct 7, 2017 in TOM by chandu (215k points)

0 votes

0 answers

If the length of the shaft is I m and c is the position of node for tensional vibrations then what is the length if AC?

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

This system may, for vibration analysis be treated as being on one shaft (integral with ) if

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Systems A and B having identical mass and springs motion. Which one of the following statements is correct?

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

After how much time will the two stones meet?

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Which one of the following principles/laws converts a dynamics problem to an equivalent statics problem?

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

what is the height reached by the balt kept on the combined springs when released?

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Herringbone gears

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The angle between the cylinders axes if the primary forces of a 2 – cylinder V – engine are to be completely balanced?

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

The problem of hunting of centrifugal governor becomes very acute when the governor becomes

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Which one of the following statements is not correct?

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Cyclical tooth profile of a cycloidal gear tooth is a combination of

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Match List – I (Gear Train) with List – II (Application)

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Examine the figure shown below where in the numbers indicate the links:

asked Oct 6, 2017 in TOM by chandu (215k points)

0 votes

0 answers

asked Oct 4, 2017 in TOM by chandu (215k points)

0 votes

0 answers

What is the value of K for which the relative damping of the closed loop system shown above is equal to 0.5?

asked Oct 2, 2017 in TOM by chandu (215k points)

0 votes

0 answers

Which one of the following is true for these two points?

asked Oct 1, 2017 in TOM by chandu (215k points)

Page:

« prev
1
...
33
34
35
36
37
38
39
40
41
...
50
next »

...